Vehicle electronics from concept to manufacture
Home > Knowledge Base

Login Knowledge Base

view RSS feed  


Keywords: General Category
   Hardware Category
   Software Category
   Sort By
  
* Please filter articles displayed by selecting required keyword from each category.

Articles:

TitleDate 
How are the RTD inputs intended to be used on the M2xx and M4xx series OpenECU
 07-May-2010 Click for more...
OpenECU 32bit Developer Platform third party tool compatibility
OpenECU has been specified to work with the following versions of industry standard tools. 		13-May-2010 Click for more...
What environmental conditions can OpenECU withstand?
 06-May-2009 Click for more...
What is the operating system (OS)? Is it OSEK compliant?
 07-May-2009 Click for more...
Does OpenECU software support variable valve timing engines?
 07-May-2009 Click for more...
What microprocessor does OpenECU use?
 06-May-2009 Click for more...
Can I schedule tasks relative to engine crank angle on G850?
 07-May-2009 Click for more...
How do I calibrate an OpenECU strategy?
 06-May-2009 Click for more...
Is it possible to integrate any of my existing 'C' code algorithms with OpenECU auto-generated code?
 06-May-2009 Click for more...
Does the OpenECU blockset allow me to handle comms over the CAN bus?
 07-May-2009 Click for more...
Can I expand the I/O over CAN?
06-May-2009 Click for more...
How much memory is available for my control application?
 06-May-2009 Click for more...
If OpenECU does not require Embedded Coder, how do I specify properties of my model variables and calibrations?
06-May-2009 Click for more...
Can OpenECU drive a stepper motor?
06-May-2009 Click for more...
Are pull-up/-down resistors on inputs and outputs software-configurable?
 06-May-2009 Click for more...
But OpenECU is an auto-coding platform - is this not detrimental to system performance?
 06-May-2009 Click for more...
Does OpenECU hardware support variable valve timing engines?
06-May-2009 Click for more...
Can Hall effect sensors be used with OpenECU as well as VRS?
 06-May-2009 Click for more...
What is the resolution of the analogue inputs?
06-May-2009 Click for more...
For engine control applications, what is the maximum engine speed limit?
06-May-2009 Click for more...
How much do the other tools I need cost?
 06-May-2009 Click for more...
Is OpenECU protected against reverse voltages, etc.?
 06-May-2009 Click for more...
Why does the G800 module not have any HEGO heater driver outputs whereas the G400 has two?
 06-May-2009 Click for more...
How do I connect my wiring loom to an OpenECU?
 07-May-2010 Click for more...
What environmental conditions can OpenECU withstand?
 08-Dec-2009 Click for more...
12



Return to top of page Return to top of page